Repsol Telex W（10w/20）

Description and Recommendations
A high quality multigrade oil made from paraffinic base stocks which are treated with special solvents during the refining process which give it better oxidation protection and an increased service life.
Selected additives are used to give them a variety of properties including outstanding anti-wear characteristics. In general this is a hydraulic fluid for use on road machinery, however, its special additives also make it suitable for use on some transmissions of the same type of machinery.
Properties
High ant-wear protection. Low pour point
Good anti-oxidation properties. High viscosity index.
Good foam prevention characteristics. High detergent-dispersant performance.
Good aging resistance.
Quality Level
DIN 51524/2 HLP (except demulsion) MAN H-LPD
AFNOR NFE 48603 HM (except demulsion) CATERPILLAR TO-2
GM Allison C-4
Technical Characteristics

Available in
875 Kg. containers.
185 and 45 Kg. drums.
Hazard Identification
This product is not classified as toxic or hazardous under current legislation.
Handling
Certain minimum precautions to avoid prolonged contact with the skin should be taken when handling. The use of gloves, visors or masks is recommended in order to avoid splashes.
Health and safety hazards
Inhalation: Minimum risk of inhalation as it is a non-volatile product.
Ingestion: Does not provoke vomiting. Drink water. Seek medical assistance.
Contact with Skin: Wash with abundant water and soap.
Eyes: Wash with abundant water.
General measures: Seek medical assistance.
Fire fighting measure
No special measures are required.
Fire control: Foams, dry chemicals, CO2, water spray. Do not apply water jet directly as this may cause the product to spread.
Environmental precautions
Danger of physical contamination in the case of spillage (water flows, coastal areas, the ground, etc.) due to its floating capacity and oily consistency which may cause damage to fauna and flora with which it comes into contact. Avoid its penetration into water containers or outlets.
Decontamination and cleaning: Treat as an accidental oil spillage. Avoid spreading by using mechanical barriers and eliminate using both physical and chemical means.

Unless otherwise specified, the values cited in technical characteristics should be considered as typical.